LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2015 >> Sonata Eco >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 74 (General Information (Body Electrical System) (HEV)) >> General Information >> General Troubleshooting Information >> Handling Wires And Harnesses

Handling Wires And Harnesses

WARNING: This page is about a different variant/trim than selected.
  1. Secure wires and wire harnesses to the frame with their respective wire ties at the designated locations.
  2. Remove clips carefully; don't damage their locks (A).
    Fig 1: Identifying Clips Locks
    G10589780Courtesy of HYUNDAI MOTOR AMERICA
  3. Slip pliers (A) under the clip base and through the hole at an angle, and then squeeze the expansion tabs to release the clip.
    Fig 2: Squeezing Expansion Tabs Using Pliers
    G10589781Courtesy of HYUNDAI MOTOR AMERICA
  4. After installing harness clips, make sure the harness doesn't interfere with any moving parts.
  5. Keep wire harnesses away from exhaust pipes and other hot parts, from sharp edges of brackets and holes, and from exposed screws and bolts.
  6. Seat grommets in their grooves properly (A). Do not leave grommets distorted (B).
    Fig 3: Caution For Grommets
    G10589782Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals