Charging System Inspection
WARNING: This page is about a different variant/trim than selected.
- Engine "ON"
- headlight and heatwire "ON".
- Measure voltage between terminal (+) and (-) of battery maintaining ENG. RPM at 2, 500 RPM (idle) over 2 minutes.
Specification: More than 10 [V]
- Is the measured voltage within specifications?
YES
- Go to "POWER CIRCUIT INSPECTION " procedure.
NO
- Check that the tension of drive belt, ENG RPM, fuse, terminal of battery, all terminals of alternator are in good condition and Check for damaged harness and poor connection between alternator and battery.
- Repair as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.