Repair Procedures: Installation

WARNING: This page is about a different variant/trim than selected.

Apply a light coat of engine oil to the oil cooler packing surface (A), and then install the oil cooler with fix bolt (B).
Tightening torque: 44.1 ~ 53.9 N.m (4.5 ~ 5.5 kgf.m, 32.5 ~ 39.8 lb-ft)

Fig 1: Identifying Oil Cooler Packing Surface And Oil Cooler Fix Bolt
Courtesy of HYUNDAI MOTOR AMERICA
CAUTION:
- Fix position of oil cooler stopper (A) where oil cooler resists on ladder frame stopper (B).
Fig 2: Identifying Oil Cooler Stopper And Ladder Frame Stopper
Courtesy of HYUNDAI MOTOR AMERICA
Apply a light coat of engine oil to the oil filter packing surface, and then install the oil filter (A).
Tightening torque: 11.8 ~ 15.7 N.m (1.2 ~ 1.6 kgf.m, 8.7 ~ 11.6 lb-ft)
Connect the oil cooler coolant hoses (B).

Fig 3: Identifying Oil Filter And Oil Cooler Coolant Hoses
Courtesy of HYUNDAI MOTOR AMERICA