Seat Cushion Cover Replacement

WARNING: This page is about a different variant/trim than selected.

Remove front seat assembly.
Remove the recliner cover.
Push the protector (A), and then seat cushion cover (C) from the frame (B).

Fig 1: Identifying Protector, Frame, And Seat Cushion Cover
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connectors (A).

Fig 2: Identifying Connectors
Courtesy of HYUNDAI MOTOR AMERICA
After removing the hogring clips (B) on the front of seat cushion and remove the seat cushion cover (A).
CAUTION:
- When removing the hog-ring clip, remove the hog-ring clip with pressing the wire not to separate the wire from the sponge.
Fig 3: Identifying Hogring Clips And Seat Cushion Cover
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.
NOTE:
- To prevent wrinkles, make sure the material is stretched evenly over the cover (B) before securing the hogring clips (A).
- Replace the hogring clips with new ones using special tool (C) (09880-4F000).
Fig 4: Identifying Hogring Clips, Seat Cushion Cover And Special Tool (09880-4F000)
Courtesy of HYUNDAI MOTOR AMERICA
NOTE:
- Be sure to perform PODS re-zero with the GDS after replacing parts (passenger's).