Recliner Cover Replacement

WARNING: This page is about a different variant/trim than selected.

Remove the recliner switch (A) and height switch (B).

Fig 1: Identifying Recliner Switch And Height Switch
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, then remove the recliner center cover (A).

Fig 2: Loosening Recliner Center Cover Mounting Screws
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, and then remove the recliner cover (A).

Fig 3: Loosening Recliner Cover Mounting Screws
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connector (A).

Fig 4: Identifying Connector
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.
NOTE:
- Be sure to perform PODS re-zero with the GDS after replacing parts (passenger's).