LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2015 >> Sonata Eco >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 67 (Fuel Delivery System (HEV)) >> Filler-Neck Assembly >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Lift the vehicle.
  2. Disconnect the fuel filler hose (A).
  3. Disconnect the ventilation hose (B) from the fuel tank air filter.
    Fig 1: Disconnecting Fuel Filler Hose & Ventilation Hose
    G10588704Courtesy of HYUNDAI MOTOR AMERICA
  4. Open the fuel filler door and then remove the filler-neck installation screw (A).
    Fig 2: Removing Filler-Neck Installation Screw
    G10588705Courtesy of HYUNDAI MOTOR AMERICA
  5. Remove the rear-LH wheel, tire, and the inner wheel house.
  6. Remove the filler-neck assembly from the vehicle after removing the bracket installation bolt (A).
    Fig 3: Removing Bracket Installation Bolt
    G10588706Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals