LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2015 >> Sonata Eco >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 67 (Fuel Delivery System (HEV)) >> Accelerator Pedal >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  2. Disconnect the accelerator position sensor connector (A).
  3. Remove the installation bolt (B) and nuts (C), and then remove the accelerator pedal module.
    Fig 1: Removing Accelerator Position Sensor Connector & Nuts
    G10588707Courtesy of HYUNDAI MOTOR AMERICA
    Fig 2: Removing Installation Bolt
    G10588708Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals