General Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
|
- Input speed sensor fault
- Output speed sensor fault
- Clutch slip in Transmission (UD brake, 2/6 brake, OWC) or oil pressure controller fault
|
| Enable Conditions |
- Solenoid power voltage> 10V
- ATF temperature Sensor > -10°C(23.8°F)
- Time after shift changing finish > 1sec.
- Input speed > 400rpm
- Output speed >200rpm
- Time after TCM turns on > 1sec.
- Shift stage 2nd. gear
- TR switch = "D" range
|
| Threshold Value |
- Output speed>(input speed+200rpm)/2nd. gear ratio
- Output speed<(input speed-200rpm)/2nd. gear ratio
|
| Diagnostic Time |
|
| Fail safe |
|