Shift cable alignment Inspection

WARNING: This page is about a different variant/trim than selected.

ⓧ P0706 is happened by malfunction of Shift Cable alignment between TGS Lever and Transmission Range Sensor. So that It must check Shift Cable alignment and Shift lever.

■ Check the Alignment of Shift Cable

Move TGS lever to "N" position, and unfasten Shift cable - Manual Control Lever nut and Transmission Range sensor 2 bolts.
Set Manual Control Lever in "N" position.
1. N setting hole (5mm)
2. Manual Control Lever
3. Shift Cable & nut (12MM)
4. Jig (5mm)
5. Transmission Range Sensor bolt (10mm)
Insert "N setting Jig ( 5)" into the "N setting hole"
Fasten the Shift cable - Manual Control Lever nut and Transmission Range sensor 2 bolts.
ⓧ Beware of pull or push between Shift Cable and Manual Control Lever.
Remove the Jig from "N setting hole"
1. Good "N" alignment
2. Faulty "N" alignment
Is the problem solved?
YES
- Go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Go to "WIRING INSPECTION " procedure.

■ Check the Shift Lever

Move shift lever "N" to "D" range.
Check the Shift lever is stop between "N" range and "D" range.
If the Shift lever is stop between "N" range and "D" range, replace Shift lever.
After complete above procedure, Move shift lever "P" to "D" range 2 times.
1. Stop between "N" and "D"
2. Stop between "N" and "D"
Is the problem solved?
YES
- Go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Go to "WIRING INSPECTION " procedure.