Scantool Diagnostics

WARNING: This page is about a different variant/trim than selected.

■ Check DTC

Connect GDS and check DTCs.
Check for CAN communication DTCs between MCU and each module.
If there any module related DTCs, check those DTC(s) first.
Erase the DTC after inspection and repair has done.
Is the DTC erased?
YES
- Check connectors of each Modules for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
- Go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Go to next procedure.