General Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
- Generator (HSG) temperature range check
- Generator (HSG) Inverter temperature range check
|
- Cooling System "A"
- Lack of EWP Coolant
- EWP Performance Fault
- Generator Motor (HSG)
- Faulty MCU (GCU)
|
| Enable Conditions |
- Ignition ON (SSB LED "BLUE")
- Aux. Battery voltage is between 9V and 16V
- When the HSG is overheated: P0A37, P0A38, P0A39.
- When the GCU is overheated: P0BCD, P0BCF, P0BCE,
- When the MCU is overheated: P0AEE, P0AF0, P0AEF not detected
|
| Threshold Value |
- If the temperature of Generator Motor (HSG) is between 320°F (160°C) and 365°F (185°C)
- If the temperature of MCU (GCU) is between 199.4°F (93°C) and 215.6°F (102°C)
|
| Diagnosis Time |
|
| DTC |
|
| MIL On Condition |
|
| Service Lamp On Condition |
|