Monitor Scantool Data
WARNING: This page is about a different variant/trim than selected.
- Ignition ON/Hybrid Ready (Cluster Indicator "READY" On) Vehicle Parked.
- Connect GDS and select "Data Analysis" mode.
- Select "Current Data" mode and monitor "Generator (HSG) Resolver Mal Counter" parameter.
Specification: Normal: 0, Abnormal: 1 ~ 132. or over 132.
- Is the measured data within specifications?
YES
- Go to "TERMINAL AND CONNECTOR INSPECTION " procedure.
NO
- Go to "Signal Circuit Inspection" procedure.