LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2015 >> Sonata Eco >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 60 (Driveshaft Assembly (HEV)) >> Front Driveshaft >> Repair Procedures >> Reassembly

Repair Procedures: Reassembly

WARNING: This page is about a different variant/trim than selected.
  1. Wrap tape around the driveshaft spline (TJ) to prevent damage to the boots.
  2. Apply grease to the joint boot on the side of the wheel and install the boot.
  3. Install the clamp.
    Fig 1: Installing Clamp On Driveshaft
    G10588935Courtesy of HYUNDAI MOTOR AMERICA
  4. To install the dynamic damper (A), keep the shaft in a straight line and assemble the dynamic damper with the bands (B).
    Fig 2: Installing Dynamic Damper With Band
    G10588936Courtesy of HYUNDAI MOTOR AMERICA
  5. Assemble the transaxle side joint boot and bands.
  6. Using the alignment marks (D) made during disassembly as a guide, install the spider assembly (A) and snap ring (B) on the driveshaft splines (C).
    Fig 3: Identifying Spider Assembly Alignment Marks (1 Of 2)
    G10588937Courtesy of HYUNDAI MOTOR AMERICA
    Fig 4: Identifying Spider Assembly Alignment Marks (2 Of 2)
    G10588938Courtesy of HYUNDAI MOTOR AMERICA
  7. Add specified grease to the joint boot as much as it was wiped away at inspection.
  8. Install the both boot band.
scientia non olet · About LEMON Manuals