Monitor GDS Data

WARNING: This page is about a different variant/trim than selected.

Connect GDS to Data Link Connector (DLC).
Using GDS, clear DTCs.
IG OFF and then, IG ON, again.
Again using GDS, Check DTC present.
Is the same DTC shown, again?
YES
- Substitute with a known-good TPMS sensor and check for proper operation. If problem is corrected, replace TPMS sensor and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Fault is intermittently caused or was repaired and TPMS ECU memory was not cleared.
  Go to "VERIFICATION OF VEHICLE REPAIR " procedure.