Monitor GDS Data
WARNING: This page is about a different variant/trim than selected.
- Connect scantool to Data Link Connector (DLC).
- Using a scantool, clear DTCs.
- IG OFF and then, IG ON, again.
- Again using scantool, Check DTC present.
- Is the same DTC shown, again?
YES
- Substitute with a known-good TPMS receiver module and check for proper operation.
If the problem is corrected, replace TPMS receiver module and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Fault is intermittent. It has been repaired and TPMS receiver module memory is not cleared yet.
Go to "VERIFICATION OF VEHICLE REPAIR " procedure.
- Substitute with a known-good TPMS receiver module and check for proper operation.