Description and Operation: Description

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying TPMS Sensor

G10589052

Courtesy of HYUNDAI MOTOR AMERICA

Mode
1. Configuration State
  1. All sensors should be in the Low Line state.
  2. In Low Line configuration, sensor transmissions occur every 1 minute (nominal) and pressure is measured every 4 seconds.
2. Normal Delayed Auto State
  1. In this state, the sensor will transmit for approx. 12 minutes before automatically entering storage state.
3. Storage Auto State
  1. This state is a Low quiescent current state.
  2. In this state;
    1. Ignition off.
    2. The sensor does not measure pressure/temperature/battery level.
4. Alert State
  1. The sensor automatically enters this state if the measured temperature exceeds 110°C and over temperature shutdown is likely.
  2. In this state, pressure is measured every 4 seconds and RF data transmitted every 4 seconds.
  3. The state lasts for 1 minute if it is pressure triggered.