Description and Operation: Description

WARNING: This page is about a different variant/trim than selected.

Fig 1: Identifying TPMS Receiver

G10589066

Courtesy of HYUNDAI MOTOR AMERICA

Mode
1. Virgin State
  - The receiver as a sole part is shipped in this state. Replacement parts should therefore arrive in this state.
  - In this state, there is no Auto-Location, no sensor wake-up, no sensor monitoring and no DTC monitoring.
  - The state indicates that platform specific parameters must be written to the receiver and that sensors are unlearned.
2. Normal State
  - In order for tire inflation state and DTC monitoring to occur, the receiver must be in this state.
  - In this state, automatic sensor location is enabled.
Overview
- Sends LF command data to initiators.
- Controls sensor state:
  Ignition on - Normal Delayed
  
  Ignition off - Storage.
- Auto-Locates sensors.
- Receives RF data from sensor.
- Uses sensor data to decide whether to turn on TREAD Lamp.
- Uses sensor information, distance traveled, background noise levels, Auto-learn status, short circuit output status, vehicle battery level, internal receiver states to determine if there is a system or a vehicle fault.