System Inspection

WARNING: This page is about a different variant/trim than selected.

Was the PCM just replaced or reflashed?
YES
- Using a scan tool, perform "VIN WRITING " procedure. Refer to the latest Reference manual for scan tool and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Using a scan tool, read VIN information.
  If there is no proper VIN information, perform "VIN WRITING " procedure.
  
  If VIN information exists, substitute with a known-good PCM and check for proper operation. If the problem is corrected, replace PCM.
  
  And go to "VERIFICATION OF VEHICLE REPAIR " procedure.