Scantool Diagnostics
WARNING: This page is about a different variant/trim than selected.
■ Check DTC
- Connect GDS and check DTCs.
- Check for CAN communication DTCs between LDC and each module.
- If there any module related DTCs, check those DTC(s) first.
- Erase the DTC after inspection and repair has done.
- Is the DTC erased?
YES
- Check connectors of each Modules for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Go to next procedure.