Cooling Fan

WARNING: This page is about a different variant/trim than selected.

Disconnect the battery negative terminals.
(Refer to ENGINE AND TRANSAXLE ASSEMBLY )
Remove the air cleaner assembly.
(Refer to ENGINE AND TRANSAXLE ASSEMBLY )
Disconnect the PWM connector (A) and radiator upper hose clip (B).

Fig 1: Disconnecting PWM Connector & Removing Radiator Upper Hose Clip
Courtesy of HYUNDAI MOTOR AMERICA
Loosen the cooling fan mounting bolts (A) and then disconnect the cooling fan assembly (B) from radiator.
Tightening torque: 4.9 ~ 7.8 N.m (0.5 ~ 0.8 kgf.m, 3.6 ~ 5.8 lb-ft)

Fig 2: Loosening Cooling Fan Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA

Fig 3: Identifying Cooling Fan Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse order of removal.