Removal and Installation

WARNING: This page is about a different variant/trim than selected.

Remove the front bumper.
(Refer to "FRONT BUMPER ")
Unfasten the 2 bolts (A) and release locking hook (B).

Fig 1: Loosening Locking Hook Bolts
Courtesy of HYUNDAI MOTOR AMERICA

Fig 2: Removing Locking Hook
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the AAF (Active Air Flap) actuator connector (A).

Fig 3: Identifying AAF Actuator Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the AAF (Active Air Flap) assembly (A).

Fig 4: Identifying AAF Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.
After installing, perform the "Actuation test" using GSD to check on the system.

Fig 5: Screen Display - Actuation Test
Courtesy of HYUNDAI MOTOR AMERICA