Repair Procedures: Replacement

WARNING: This page is about a different variant/trim than selected.

NOTE:

After remove the rear combination lamp.
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts your hands.
Put on gloves to protect your hands.
Take care not bend or scratch the cover and other parts.

Remove the following items.
1. Luggage cover mat
  (Refer to "TRUNK TRIM ")
2. Transverse trim
  (Refer to "TRUNK TRIM ")
3. Luggage side trim
  (Refer to "TRUNK TRIM ")
Disconnect the connector (A), and then remove the rear combination lamp mounting nuts.
Remove the rear combination lamp (B).

Fig 1: Identifying Connector And Rear Combination Lamp
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the rear bumper side's mounting clip and screws, then disconnect the side's.

Fig 2: Loosening Rear Bumper Side Mounting Clip And Screws
Courtesy of HYUNDAI MOTOR AMERICA
Loosen the mounting screws and clips.

Fig 3: Loosening Mounting Screws And Clips
Courtesy of HYUNDAI MOTOR AMERICA
Loosen the mounting bolts.

Fig 4: Loosening Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connector (A).

Fig 5: Identifying Connector
Courtesy of HYUNDAI MOTOR AMERICA
Loosen the rear bumper cover mounting screws and clips, and then remove the rear bumper cover (A).

Fig 6: Loosening Rear Bumper Side Mounting Clip And Screws
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.
NOTE:
- Replace any damage clips.