Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.

Loosen the drain plug (A), and drain the inverter coolant. Remove the inverter reservoir cap to help drain the coolant faster.

Fig 1: Identifying Coolant Drain Plug
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the reservoir inlet hose (A) and outlet hose and pipe assembly (B), then remove the reservoir (C).
Tightening torque: 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

Fig 2: Identifying Reservoir Inlet Hose, Outlet Hose & Pipe Assembly And Reservoir
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.
Fill the reservoir with coolant and check for leaks.
NOTE: Bleed air from the hybrid motor cooling system using GDS. (Refer to "COOLANT ")