Outside Handle Replacement

WARNING: This page is about a different variant/trim than selected.

After loosening the mounting bolt, then remove the outside handle cover (A).
Tightening torque: 0.7 ~ 0.5 N.m (0.07 ~ 0.1 kgf.m, 1.0 ~ 0.7 lb-ft)

Fig 1: Removing Outside Handle Cover
Courtesy of HYUNDAI MOTOR AMERICA
Remove the outside handle (A) by sliding it rearward.

Fig 2: Sliding Outside Handle
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.