Module Assembly Replacement

WARNING: This page is about a different variant/trim than selected.

Remove the following parts:
- Door trim
- Window glass
- Outside handle
- Rear channel
Loosen the mounting screw (A).

Fig 1: Loosening Mounting Screw
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the door module mounting bolts, remove the door module (A).
Tightening torque: 6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)

Fig 2: Removing Door Module
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connector (A).
Detach the clips, then remove the wiring harness (B).

Fig 3: Disconnecting Connector & Removing Wiring Harness
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.
NOTE:
- The area of whole parts should be applied with sufficient grease.
- Make sure connectors are connected properly and each rod is connected securely.
- Make sure the door locks/unlocks and opens/closes properly.