Glass Replacement

WARNING: This page is about a different variant/trim than selected.

NOTE: Put on gloves to protect your hands.

Remove the rear door trim.
Remove the rear door belt inside weatherstrip (A).

Fig 1: Removing Rear Door Belt Inside Weatherstrip
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, then remove the delta outer cover (A).

Fig 2: Removing Delta Outer Cover
Courtesy of HYUNDAI MOTOR AMERICA
Release the rear channel mounting bolts and nut.
Remove the glass mounting hole plug (A).
NOTE:
- Using the door switch to align the mounting hole with the hole on the door glass.
- If it is impossible, align the hole by hand after removing the motor.
- Be careful not to drop to glass and scratch the glass surface.
Carefully move the glass (B) until you can see the bolts, then loosen them. Separate the glass from the glass run and carefully pull the glass out through the window slot.
Tightening torque: 3.9 ~ 2.9 N.m (0.4 ~ 1.2 kgf.m, 11.8 ~ 8.7 lb-ft)

Fig 3: Removing Glass Mounting Hole Plug & Adjusting Glass Position
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.
NOTE:
- Roll the glass up and down to see if it move freely without binding.
- Adjust the glass position as needed.