Outside Rear View Mirror Replacement

WARNING: This page is about a different variant/trim than selected.

NOTE:

When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.

Using a screwdriver, remove the quadrant inner cover (A).

Fig 1: Removing Quadrant Inner Cover
Courtesy of HYUNDAI MOTOR AMERICA
After disconnecting the connector (A), remove the outside rear view mirror (B).
Tightening torque: 6.9~10.8 N.m (0.7~1.1 kgf.m, 5.1~8.0 lb-ft)

Fig 2: Disconnecting Connector & Removing Outside Rear View Mirror
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.