Hood Latch Replacement

WARNING: This page is about a different variant/trim than selected.

Remove the front bumper cover.
(Refer to the "FRONT BUMPER ")
After loosening the mounting bolt and clips, then remove hood latch cover (A).

Fig 1: Removing Hood Latch Cover
Courtesy of HYUNDAI MOTOR AMERICA
Remove the hood latch (A) mounting bolts.
Tightening torque: 7.8~11.8 N.m (0.8~1.2 kgf.m, 5.8~8.7 lb-ft)

Fig 2: Removing Hood Latch Mounting Bolts
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the hood latch cable (A) and remove the latch (B).

Fig 3: Disconnecting Hood Latch Cable & Removing Latch
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.
NOTE:
- Make sure the hood latch cable is connected properly.
- Make sure the hood locks/unlocks and opens/closes properly.