Outside Handle Replacement

WARNING: This page is about a different variant/trim than selected.

After loosening the mounting bolt, then remove the outside handle cover (A).
Tightening torque: 0.7~0.5 N.m (0.07~0.1 kgf.m, 1.0~0.7 lb-ft)

Fig 1: Removing Outside Handle Cover
Courtesy of HYUNDAI MOTOR AMERICA
Remove the outside handle (A) by sliding it rearward.

Fig 2: Sliding Outside Handle
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connector (A).

Fig 3: Disconnecting Connector
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.
NOTE:
- Make sure the door locks/unlocks and opens/closes properly.