Door Module Assembly Replacement

WARNING: This page is about a different variant/trim than selected.

Remove the following parts:
1. Door trim
2. Window glass
3. Outside handle
Loosen the mounting screw (A).

Fig 1: Loosening Mounting Screw
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the door module mounting bolts, then remove the door module (A).
Tightening torque: 6.9~10.8 N.m (0.7~1.1 kgf.m, 5.1~8.0 lb-ft)

Fig 2: Removing Mounting Bolts & Door Module
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connectors (A) and door module wiring harness (B).

Fig 3: Identifying Door Module Wiring Harness & Connectors
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.
NOTE:
- The area of whole parts should be applied with sufficient grease.
- Make sure connectors are connected properly and each rod is connected securely.
- Make sure the door locks/unlocks and opens/closes properly.