LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2015 >> Sonata Eco >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 52 (Exterior Body Panels (HEV)) >> Fender >> Repair Procedures >> Replacement

Repair Procedures: Replacement

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • Be careful not to damage the hood and body.
  • Use a clip remover when removing clips.
  1. Remove the front bumper.

    (Refer to the "FRONT BUMPER ")

  2. Loosen the mud guard mounting screws.
    Fig 1: Loosening Mud Guard Mounting Screws
    G10589452Courtesy of HYUNDAI MOTOR AMERICA
  3. After loosening the mounting screws and clips, then remove the side sill garnish (A).
    Fig 2: Removing Side Sill Garnish
    G10589453Courtesy of HYUNDAI MOTOR AMERICA
  4. After loosening the mounting screw and bolt, then remove the front bumper side mounting bracket (A).
    Fig 3: Removing Front Bumper Side Mounting Bracket
    G10589454Courtesy of HYUNDAI MOTOR AMERICA
  5. After loosening the fender mounting screw and bolts, then remove the fender (A).
    Fig 4: Removing Fender
    G10589455Courtesy of HYUNDAI MOTOR AMERICA
  6. Installation is the reverse of removal.
scientia non olet · About LEMON Manuals