LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2015 >> Sonata Eco >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 52 (Exterior Body Panels (HEV)) >> Body Side Moldings >> Repair Procedures >> Replacement >> Trunk Lid Garnish Replacement

Trunk Lid Garnish Replacement

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damaged.
  • Put on gloves to protect your hands.
  • Take care not to scratch the body surface.
  1. Remove the trunk lid trim.

    (Refer to the "Trunk Lid ")

  2. After loosening the mounting nuts, then remove the rear combination lamp (A).
    Fig 1: Removing Rear Combination Lamp
    G10589520Courtesy of HYUNDAI MOTOR AMERICA
  3. Using a screwdriver or remover, remove the trunk lid garnish (A).
    Fig 2: Removing Trunk Lid Garnish
    G10589521Courtesy of HYUNDAI MOTOR AMERICA
  4. Disconnect the connector (A).
    Fig 3: Identifying Trunk Lid Harness Connector
    G10589522Courtesy of HYUNDAI MOTOR AMERICA
  5. Installation is the reverse of removal.
    NOTE:
    • Replace any damage clips.
    • Make sure the trunk lid locks/unlocks and opens/closes properly.
scientia non olet · About LEMON Manuals