Exhaust Camshaft Bearing

WARNING: This page is about a different variant/trim than selected.

Check the cylinder head bore mark.

Cylinder Head Bore Identification Mark

Fig 1: Locating Cylinder Head Bore Identification Mark

Courtesy of HYUNDAI MOTOR AMERICA

CYLINDER HEAD INSIDE DIAMETER SPECIFICATIONS

Class	Mark	Exhaust No. 1 Inside Diameter Of Cylinder Head Bore
a	A	40.000 ~ 40.008 mm (1.57480 ~ 1.5751 in.)
b	B	40.008 ~ 40.016 mm (1.57511 ~ 1.57543 in.)
c	C	40.016 ~ 40.021 mm (1.57543 ~ 1.57563 in.)

Select class of camshaft bearing same as class of cylinder head as shown on the table below.

Exhaust Camshaft Bearing Identification Mark

Fig 2: Identifying Exhaust Camshaft Bearing Color

Courtesy of HYUNDAI MOTOR AMERICA

EXHAUST CAMSHAFT BEARING THICKNESS SPECIFICATIONS

Cylinder Head Bore Class	Bearing Class For Installing (Color)	Thickness Of Bearing
a (A)	C (Green)	1.996~2.000 mm (0.07858~0.07874 in.)
b (B)	B (None)	2.000~2.004 mm (0.07874~0.07890 in.)
c (C)	A (Black)	2.004~2.008 mm (0.07890~0.07905 in.)

Oil clearance: 0 ~ 0.032 mm (0 ~ 0.00126 in.)