Repair Procedures: Removal
WARNING: This page is about a different variant/trim than selected.
CAUTION:
- Put on gloves to protect your hands.
- Take care not to body surface and other parts.
- Remove the following parts
- Rear seat assembly
(Refer to the "REAR SEAT ")
- Rear pillar trim
(Refer to the "INTERIOR TRIM ")
- Rear seat assembly
- Loosen the quarter fixed glass (A) mounting nut.
Tightening torque: 3.9 ~ 4.4 N.m (0.4 ~ 0.45 kgf.m, 2.9 ~ 3.3 lb-ft)
- Cut out the sealant using the sealant cutting tool [09861-31100].CAUTION:
- Do not scrape down to the painted surface of the body; damaged paint will interfere with proper bonding.
- Remove the rubber dam and fasteners from the body.
- Mask off surrounding surfaces before painting.
- Remove the quarter fixed glass.