Package Tray Trim Replacement

WARNING: This page is about a different variant/trim than selected.

Remove the rear seat assembly.
(Refer to the "REAR SEAT ")
After loosening the mounting bolt, then remove the rear seat belt lower anchor (A).
[LH, RH]

Tightening torque: 39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

Fig 1: Removing Rear Seat Belt Lower Anchor (LH, RH)
Courtesy of HYUNDAI MOTOR AMERICA

[Center]

Tightening torque: 39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

Fig 2: Removing Rear Seat Belt Lower Anchor (Center)
Courtesy of HYUNDAI MOTOR AMERICA
Remove the rear pillar trim (A).

Fig 3: Removing Rear Pillar Trim
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, then remove the package tray trim (A).

Fig 4: Removing Package Tray Trim
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.