Center Pillar Trim Replacement

WARNING: This page is about a different variant/trim than selected.

NOTE:

Put on gloves to protect your hands.
When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
Take care not to bend or scratch the trim and panels.

Remove the front door scuff trim and rear door scuff trim.
Using a screwdriver or remover, remove the seat belt lower anchor (A).

Fig 1: Removing Seat Belt Rear Anchor
Courtesy of HYUNDAI MOTOR AMERICA
Remove the center pillar lower trim (A).

Fig 2: Identifying Center Pillar Lower Trim
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, then remove the center pillar upper trim (A).

Fig 3: Removing Center Pillar Upper Trim
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.
NOTE:
- Replace any damaged clips.