Glove Box Replacement

WARNING: This page is about a different variant/trim than selected.

Remove the crash pad garnish.
Remove the center fascia panel.
Using a screwdriver or remover, remove the crash pad side cover (A).

Fig 1: Identifying Crash Pad Side Cover
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the guide (B) from the glove box (A).

Fig 2: Disconnecting Guide From Glove Box
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the pin (A) and then remove the glove box (B).

Fig 3: Disconnecting Pin & Removing Glove Box
Courtesy of HYUNDAI MOTOR AMERICA
Remove the glove box lower panel (A).
Disconnect the connector (B).

Fig 4: Identifying Lower Panel And Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the glove box hose cover (A) by sliding it upward.
Remove the glove box hose (B) by sliding it upward.

Fig 5: Sliding Glove Box Hose Cover Upwards
Courtesy of HYUNDAI MOTOR AMERICA

Fig 6: Sliding Glove Box Hose Upwards
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws and nuts, then remove the glove box housing (A).

Fig 7: Removing Glove Box Housing
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.
NOTE:
- Make sure the connector is plugged in properly.