LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2015 >> Sonata Eco >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 47 (Interior Trim & Glass (HEV)) >> Crash Pad >> Repair Procedures >> Replacement >> Crash Pad Replacement

Crash Pad Replacement

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
  • Put on gloves to protect your hands.
  1. Remove the following items:
    1. Front seat (Refer to the "FRONT SEAT ")
    2. Front pillar trim

      (Refer to the "INTERIOR TRIM ")

    3. Floor console (Refer to the "CONSOLE ")
    4. Center fascia panel
    5. Cluster assembly
    6. Audio assembly
    7. Glove box & Glove box housing
    8. Crash pad side cover
    9. Steering column

      (Refer to the "STEERING COLUMN AND SHAFT ")

  2. Using a screwdriver or remover, remove the center speaker grill (A).
    Fig 1: Identifying Center Speaker Grill
    G10589571Courtesy of HYUNDAI MOTOR AMERICA
  3. After loosening the mounting screws, then remove the center speaker (A).
  4. Disconnect the connector (B).
    Fig 2: Removing Center Speaker And Connector
    G10589572Courtesy of HYUNDAI MOTOR AMERICA
  5. After loosening the mounting screw, then remove the air duct (A).
    Fig 3: Removing Air Duct
    G10589573Courtesy of HYUNDAI MOTOR AMERICA
  6. Using a screwdriver or remover, remove the start/stop button (A).
  7. Disconnect the start/stop button connector (B).
    Fig 4: Removing Start/Stop Button And Button Connector
    G10589574Courtesy of HYUNDAI MOTOR AMERICA
  8. Disconnect the passenger's airbag connector (A).
  9. Loosen the mounting bolts.
    Fig 5: Removing Passenger Airbag Connector
    G10589575Courtesy of HYUNDAI MOTOR AMERICA
  10. After loosening the mounting screws, then remove key set bezel (A).
    Fig 6: Removing Key Set Bezel
    G10589576Courtesy of HYUNDAI MOTOR AMERICA
  11. Using a screwdriver or remover, remove the photo sensor (A).
  12. Disconnect the photo sensor connector (B).
    Fig 7: Removing Photo Sensor Connector
    G10589577Courtesy of HYUNDAI MOTOR AMERICA
  13. After loosening the mounting bolts and nuts, then remove the crash pad (A).
    Fig 8: Removing Crash Pad
    G10589578Courtesy of HYUNDAI MOTOR AMERICA
  14. Installation is the reverse of removal.
    NOTE:
    • Make sure the crash pad fits onto the guide pins correctly.
    • Before tightening the bolts, make sure the crash pad wire harnesses are not pinched.
    • Make sure the connectors are plugged in properly, and the antenna lead is connected properly.
    • Enter the anti- theft code for the radio, then enter the customer's radio station presets.
scientia non olet · About LEMON Manuals