Cluster Replacement

WARNING: This page is about a different variant/trim than selected.

NOTE:

When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.

Using a screwdriver or remover, remove the cluster fascia panel (A).

Fig 1: Identifying Cluster Fascia Panel
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, then remove the cluster assembly (A).

Fig 2: Removing Cluster Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connector (A).

Fig 3: Identifying Connector
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse the removal.
NOTE:
- Make sure the connectors are connected properly.