Center Fascia Panel Replacement

WARNING: This page is about a different variant/trim than selected.

NOTE:

When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.

Using a screwdriver or remover, remove the crash pad garnish (A).

Fig 1: Identifying Crash Pad Garnish
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, then remove the center fascia panel (A).

Fig 2: Removing Center Fascia Panel
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the clock switch connector (A).

Fig 3: Disconnecting Clock Switch Connector
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the air conditioning and heater control unit connector (A) indoor temperature sensor connector (B), hose (C).

Fig 4: Disconnecting Air Conditioning And Heater Control Unit Connector, Indoor Temperature Sensor Connector And Hose
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse the removal.
NOTE:
- Make sure the connector is connected properly.