Floor Console Replacement

WARNING: This page is about a different variant/trim than selected.

NOTE:

When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Put on gloves to protect your hands.

Using a screwdriver or remover, remove the crash pad garnish (A).

Fig 1: Identifying Crash Pad Garnish
Courtesy of HYUNDAI MOTOR AMERICA
Using a screwdriver, remove the knob (A) and boots (B).

Fig 2: Removing Knob And Boots
Courtesy of HYUNDAI MOTOR AMERICA
Using a screwdriver or remover, remove the console upper cover (A).

Fig 3: Identifying Console Upper Cover
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connectors (A).

Fig 4: Identifying Connectors (1 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA

Fig 5: Identifying Connectors (2 Of 2)
Courtesy of HYUNDAI MOTOR AMERICA
Remove the console tray mat (A).

Fig 6: Identifying Console Tray Mat
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws and bolts, then remove the rear console assembly (A).

Fig 7: Removing Rear Console Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connector (A).

Fig 8: Identifying Connector
Courtesy of HYUNDAI MOTOR AMERICA
Remove the extension side cover (A).

Fig 9: Identifying Extension Side Cover
Courtesy of HYUNDAI MOTOR AMERICA
After loosening the console mounting screws, then remove the console assembly (A).

Fig 10: Removing Console Assembly
Courtesy of HYUNDAI MOTOR AMERICA
Installation is the reverse of removal.
NOTE:
- Make sure all connectors are connected properly.
- Replace any damage clips.