Fuel Tank Line Inspection
WARNING: This page is about a different variant/trim than selected.
- Relieve the fuel system pressure and remove the fuel tankCAUTION: Before removing the fuel tank, make sure the fuel hoses are not leaking.
- Block all of the following outlets:
- Fuel lines
- Fuel filler neck
- Apply maximum of 10cmHg(4 inHg) pressure to the EVAP. hose at the fuel tank. Then, pinch the EVAP. hose to retain the pressure.
- Check the suspect area for leaks with a soap solution.
- Were any leak(s) found?
YES
- Repair or replace leaking system component(s) and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Check for poor connection between PCM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.