Verification Of Vehicle Repair
WARNING: This page is about a different variant/trim than selected.
After A Repair, It Is Essential To Verify That The Fault Has Been Corrected.
- Connect Gds And Select "DTC Analysis" Mode.
- Click "DTC Status" And Confirm That "DTC Readiness Flag" Indicates "Complete". If Not, Drive The Vehicle Within Conditions Noted In The Freeze Frame Data Or Enable Conditions.
- Read "DTC Status" Parameter.
- Is Parameter Displayed "History (Not Present) Fault"?
Yes
- System Performing To Specification At This Time. Clear The DTC.
No
- Go To The Applicable Troubleshooting Procedure.