General Information: DTC Detecting Condition

WARNING: This page is about a different variant/trim than selected.

Item		Detecting Condition	Possible Cause
DTC Strategy		Calculation of engine roughness	Faulty spark plugs or Ignition coil Incorrect valve timing Uneven compression Air leakage Improper Fuel pressure or dirty fuel. Blocked/Leaking injectors Leakage between cooling system and cylinder
Enable Conditions		Engine load ratio: 14~64% 500< Engine speed(rpm) <6700 Mass air flow gradient/sec.: 12~60% Throttle gradient/sec.: 0.5~10.5% Coolant temperature >20°C(68°F) if start temperature <- 7°C(19°F) No relevant failure Fuel cut-off not active 11V< Battery voltage <16V
Threshold Value	Case 1	Misfire ratio: 9.1 % - 50 % within 200 rev.
Threshold Value	Case 2	Misfire ratio: 2.3% within 1, 000 rev.
Diagnosis Time	Case 1	200 rev. or 3*200 rev.
Diagnosis Time	Case 2	1000 rev. or 4*1000 rev.
MIL On Condition	Case 1	Immediate
MIL On Condition	Case 2	2 Driving Cycles