Monitor GDS Data

WARNING: This page is about a different variant/trim than selected.

Allow the engine to cool completely.
Run the cold engine at idle for 5 minutes and observe cooling fan status.
NOTE: Ensure that the A/C is OFF.
Check the engine coolant temperature parameter at idle with the GDS.
Is the engine coolant temperature increase to above 50°C(122°F)
YES
- Go to "TERMINAL AND CONNECTOR INSPECTION " procedure.
NO
- Go to next step as below.
Are the cooling fans running when engine coolant temperature is low (less than approximately 98°C(208°F)) with A/C OFF?
YES
- Check for short circuit in cooling fan harness or cooling fan relay. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- With ignition "ON", Install GDS and select "COOLING FAN RELAY" on the Actuation Test mode.
- Activates "COOLING FAN RELAY" by pressing "STRT(F1)" key.
- Repeat this procedure 4 or 5 times to ensure cooling fan reliability.
- If cooling fan works properly, go to next step as below.
- If NG, check for intermittent fault caused by poor contact in the sensor's and/or PCM's connector. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.