Monitor Scantool data
WARNING: This page is about a different variant/trim than selected.
- Connect GDS to DLC.
- Check for PCM DTC(s).
- Clear any PCM DTC(s).
- If no PCM DTC(s), select the "Engine RPM" parameter.
- Engine RUNNING: Observe Engine RPM while varying RPM's
- Is the Engine RPM normal?
YES
- Check for any related CAN DTC(s) and repair or replace as necessary. Clear DTC(s) and confirm no DTC(s) return.
- This is a intermittent problem caused by poor contact of Control Module
- Thoroughly check the looseness, poor connection, bent, corrosion, contamination, deformation or damage of connector.
- Repair or replace as necessary and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Check Engine RPM, circuit, or related component. Repair or replace as necessary and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.