General Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
|
- Open in signal (Feedback signal), Power or Ground circuit
- Faulty Mode Actuator
- Faulty Air conditioner Control Unit
|
| Enable Conditions |
|
| Threshold Value |
- Mode Actuator Sensor signal is at or below 0.1V for 0.3 seconds
|
| Fail-Safe |
- If the Mode actuator is placed at Vent mode right before fail detection, Actuator is operated and fixed to Vent Mode Position.
- The others mode are selected, Actuator is moved to DEF mode position
|