LEMON Manuals: Even more car manuals for everyone
Home >> Hyundai >> 2015 >> Sonata Eco >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 118 (Body Control Module (BCM) Diagnosis (HEV)) >> DTC B1613: CAN Timeout Between IPM And CLU >> Verification of Vehicle Repair

Verification of Vehicle Repair

WARNING: This page is about a different variant/trim than selected.

After a repair, it is essential to verify that the fault has been corrected.

  1. Connect scan tool and select "DTC Analysis" mode.
  2. Clear the DTCs and Operate the vehicle within DTC Enable conditions in DTC DETECTING CONDITION .
  3. Is any DTC outputted again?

    YES 

    • Go to the applicable troubleshooting procedure.

    NO 

    • System performing to specification at this time.
scientia non olet · About LEMON Manuals