Brake Wheel Line Bleeding Procedure

WARNING: This page is about a different variant/trim than selected.

CAUTION: The 12V battery can be discharged if the brake pedal is excessively depressed without the engine running.

Make sure the brake fluid in the reservoir is at the MAX (upper) level line.
Use the air bleeding tool (SST:09580-3D100) and feed oil pressure 0.3~0.35 MPa (43.5~50.7 psi) into the reservoir.
Loosen the bleed screw (A) on the wheel and initiate air bleeding on all the wheels.
[Front]

Fig 1: Identifying Bleed Screw On Wheel (Front)
Courtesy of HYUNDAI MOTOR AMERICA

[Rear]

Fig 2: Identifying Bleed Screw On Wheel (Rear)
Courtesy of HYUNDAI MOTOR AMERICA

CAUTION: When bleeding air, make sure the brake fluid level does not go below the "MIN" line.
Repeat the procedure for wheel in the sequence shown in illustration below until air bubbles no longer appear in the fluid.

Fig 3: Brake Bleeding Sequence
Courtesy of HYUNDAI MOTOR AMERICA
Tighten the bleeder screw.
Tightening torque: 6.9 ~ 12.7 N.m (0.7 ~ 1.3 kgf.m, 5.1 ~ 9.4 lb-ft)
Refill the master cylinder reservoir to MAX (upper) level line.