Air Bleeding Tool Installation Procedure

WARNING: This page is about a different variant/trim than selected.

CAUTION: To prevent the brake fluid reservoir tank from being damaged and ensure the safety of worker, set the pressure of the gauge to the standard value before installing the SST.

Before installing the SST on the vehicle, close the air shut-off valve (A) to adjust the pressure gauge to the standard value.

Fig 1: Identifying Air Shut-Off Valve & Plug
Courtesy of HYUNDAI MOTOR AMERICA

CAUTION: For safety of worker and correct pressure setting, make sure that the plug (B) is installed correctly.
After connecting an air hose and opening the air shut-off valve (A), adjust the pressure gauge (B) with the pressure adjuster (C) to the standard value.
Standard pressure value: 0.3 ~ 0.35 MPa (43.5 ~ 50.7 psi)

Fig 2: Identifying Air Shut-Off Valve, Pressure Gauge And Pressure Adjuster
Courtesy of HYUNDAI MOTOR AMERICA
Remove the brake reservoir tank cap.
Install the cap (A) of SST (09580-3D100) on the reservoir tank.

Fig 3: Identifying SST Cap
Courtesy of HYUNDAI MOTOR AMERICA

NOTE: Before using the SST adapter, fill up the reservoir tank with brake fluid.
Fix the adapter to the master cylinder with a SST adapter wire (A).

Fig 4: Identifying SST Adapter Wire
Courtesy of HYUNDAI MOTOR AMERICA
Make sure the check valve (A) is closed, remove the plug from the SST hose and connect it to the adapter (B).

Fig 5: Identifying Check Valve And Adapter
Courtesy of HYUNDAI MOTOR AMERICA